Nectre Fireplaces MK2 LE Operating Instructions Manual

Nectre Fireplaces MK2 LE Operating Instructions Manual

Advertisement

Nectre MK2 LE
Operating Instructions
Keep these instructions for future reference
Glen Dimplex Australia proudly supports the activities of Landcare Australia through its membership of the AHHA
Revision B

Advertisement

Table of Contents
loading

Summary of Contents for Nectre Fireplaces MK2 LE

  • Page 1 Nectre MK2 LE Operating Instructions Keep these instructions for future reference Glen Dimplex Australia proudly supports the activities of Landcare Australia through its membership of the AHHA Revision B...
  • Page 2: Table Of Contents

    OPERATING ............... 1 THE OPERATING INSTRUCTIONS IN THIS MANUAL APPLY 1.1. IMPORTANT INFORMATION ........1 TO THE NECTRE MK2 LE WOOD HEATER MODELS. 1.2. GENERAL OPERATION ..........2 THEY HAVE BEEN TESTED FOR EMISSIONS AND EFFICIENCY AND COMPLY ACCORDING TO AS/NZS 4012 &...
  • Page 3: General Operation

    1.2. GENERAL OPERATION 1.3. USING THE APPLIANCE FOR THE FIRST TIME  Air Controls For the first few times the appliance is lit, odorous fumes will be given off as the paint cures.  Do not touch the paint work while it is curing otherwise it The top air slide allows air to enter the firebox from above the can leave a permanent mark on the appliance.
  • Page 4: Running The Appliance

    1.6. RUNNING THE APPLIANCE 1.7. BURNING TIPS High Heat Output Fuel Quality This setting is not the most energy efficient as some heat is Use wood with a moisture content of less than 20%. Logs lost up the flue instead of being transferred into the room. should not feel moist or have moss and fungal growths.
  • Page 5: Ash Removal

    1.8. ASH REMOVAL 3) Grab the end of the rope from inside the firebox and pull the brush down through the flue. 4) Check the inside of the flue with the mirror and torch. Depending on the type of wood burnt and frequency, the 5) Repeat cleaning process if necessary.
  • Page 6: Maintenance And Servicing

    2.3. REPLACING THE BAFFLE PLATES 2. MAINTENANCE AND SERVICING The baffle plates help to retain the heat in the firebox by lengthening the path of the flame before it goes up the flue. 2.1. REPLACING THE FIRE BRICKS Over time, the baffle plates will begin to sag a little due to the excessive heat.
  • Page 7: Replacing The Ash Plate

    2.4. REPLACING THE ASH PLATE The ash plate acts to protect the front of the firebox below the door opening from the hot coal bed and fire. Over time, this may burn through in which case it should be replaced to ensure the longevity of the firebox. Clear ash away from the base of the ash plate.
  • Page 8: Replacement Spare Parts List

    2.8. REPLACEMENT SPARE PARTS LIST 3. WARRANTY Glen Dimplex Australia Pty. Ltd. warrants this stove to be able Firebricks to operate under normal use and service and within 10 years 9 @ 230mm x 115mm x 38mm from the date of the original purchase on the terms herein shall repair or replace without cost to the original customer 2 @ 230mm x 55mm x 38mm any part thereof which shall be returned to our factory,...

Table of Contents