Related Manuals for Nectre Fireplaces MK3
Summary of Contents for Nectre Fireplaces MK3
-
Page 1: Installation Instructions
Nectre MK3 Installation Instructions Pecan Engineering Pty Limited proudly supports the activities of Landcare Australia through its membership of the AHHA... -
Page 2: Installing The Heater
THE INSTALLATION INSTRUCTIONS IN THIS 2. INSTALLING THE HEATER MANUAL APPLY TO THE NECTRE MK3. IT HAS BEEN TESTED FOR EMISSIONS AND EFFICIENCY Positioning the Heater AND COMPLIES ACCORDING TO AS/NZS 4012:2014 & AS/NZS 4013:2014. First review the necessary clearances specified below before considering where to position the heater. -
Page 3: Corner Installation
For example: either side of the door opening, and extend under the heater. Side wall clearance for the MK3 is 400 mm. Minimum dimensions for floor protector are 900mm wide by A 12mm gapped shield on the wall with a factor of 0.40. -
Page 4: Installing The Flue
If the draft is insufficient or periodic down drafting occurs and 4. INSTALLING THE FLUE the heater smokes or only burns slowly, extending the flue or fitting a specialized cowl will usually resolve the issue. The flue system used when installing the heater MUST comply with the current installation standard AS/NZS 2918. - Page 5 5. INSTALLING FIRE BRICKS Upper baffle plate Lower baffle plate support lug Upper baffle plate The Nectre MK3 comes with 11 full size bricks (230(h) Lower baffle plate support lug x 115(w) x 38(d)mm). Raise the brick retainer (supplied inside the firebox) and start standing the bricks up against the rear and sides of the firebox as shown in the diagram below.
-
Page 6: Technical Drawings
8. TECHNICAL DRAWINGS Pecan Engineering Pty Limited 13 Acorn Road, Dry Creek South Australia 5094 T: (08) 8349 8332 | F: (08) 8260 6643 Email info@pecan-eng.com.au...