Table of Contents
Advertisement
Nighthawk SX10 Pro Gaming Advanced 8-Port Gigabit Ethernet Switch Model GS810EMX
Resolve a Subnet Conflict to Access the
Switch
If you power on the switch before you connect it to a network that includes a DHCP
server (or a router that functions as a DHCP server), the switch uses its own default IP
address of 192.168.0.239. This subnet might be different from the subnet used in your
network.
To resolve this subnet conflict:
1. Disconnect the Ethernet cable between the switch and your network.
2. Unplug the power adapter of the switch.
3. Reconnect the Ethernet cable between the switch and your network.
4. Plug the power adapter of the switch into an electrical outlet.
The switch powers on. The DHCP server in the network discovers the switch and
assigns it an IP address that is in the correct subnet for the network.
Hardware Troubleshooting Chart
The following table lists symptoms, possible causes, and possible solutions for hardware
problems that might occur.
Table 4. Troubleshooting chart
Symptom
The Power LED is off.
A port LED is off when the
port is connected to a
powered-on device.
Diagnostics and
Troubleshooting
Possible Cause
Power is not supplied to the switch
or the Power LED is disabled.
The port connection is not working
or the port LED is disabled or
dimmed.
107
Possible Solution
Check the power cable connections at the
switch and the power source.
Make sure that all cables are used correctly
and comply with the Ethernet specifications.
Make sure that the Power LED is enabled.
Check the crimp on the connectors and make
sure that the plug is properly inserted and
locked into the port at both the switch and
the connecting device.
Make sure that all cables are used correctly
and comply with the Ethernet specifications.
Check for a defective port, cable, or module
by testing them in an alternate environment
where all products are functioning.
Make sure that the port LED is enabled and
sufficiently bright.
User Manual
Advertisement
Table of Contents
