Memory Mode; Selecting Effect Programs; Program; Assignable Block And Pedal Switch Functions - Yamaha GW50 Owner's Manual

1.
Select the Memory mode by pressing
(even if the MEMORY LED is
lit).
2.
Use the buttons to step up or down
through the programs in order, or use the
Pedal Switches. (See page 11 for more details
on using the Pedal Switches.)
The effect program name appears in the
LCD.
Note:
If the cursor arrow in the display is at "TEMPO,"
"SONG" or "PTN," the [–]/[+] cannot be used
to select effect programs and the Backing-
related display appears instead of the effect
program name. In this case, use [6 CURSOR] to
move the cursor arrow "out" of the display.
In the Memory mode, effect parameters cannot be
edited (this is done in the Manual mode or
Memory Edit mode). However, you can check the
values of the main parameters of the selected
effect program by turning the desired parameter
knob. The selected parameter's current value is
shown in the screen and does not change even
when the knob is turned. (Sub parameters cannot
be viewed from the Memory mode. However, you
can check these values without altering them from
the Memory Edit mode; see page 53.)

MEMORY MODE

1.
2.
EFFECT SECTION
Making sure that MEMORY is selected in
the ASSIGNABLE Block (the MEMORY
LED should be lit; if flashing, press the
ASSIGNABLE Block Pedal Switch once),
press the desired Pedal Switch, 1–5. This
selects programs 1–5 in the current bank. For
example, if bank 2 is currently selected,
pressing Pedal Switch 3 selects program
number 23.
To change among banks 1–5, press the AS-
SIGNABLE Block Pedal Switch and then the
appropriate Pedal Switch, 1–5.
1) Press ASSIGNABLE Block Pedal Switch...
2) ...then press Pedal Switch 1–5.
To change among banks 6–0, simultaneously
hold down the ASSIGNABLE Pedal Switch
and then the appropriate Pedal Switch, 6–0.
1) While holding down ASSIGNABLE Block Pedal Switch...
2) ...press Pedal Switch, 6–0.
MEMORY MODE
MEMORY MODE
51