Effect Program Selection; Job Table - Yamaha GW50 Owner's Manual

SUPPLEMENTAL INFORMATION

JOB TABLE

* In this chart, a plus mark between two button names (for example, SHIFT + SUB PARAM )
indicates that the two are to be pressed simultaneously. An arrow between buttons
(for example,
* —Main modes
MANUAL mode— MANUAL
• Editing main parameters—Parameter knobs
• Editing sub parameters and Noise Gate— SHIFT + SUB PARAM
• Utility functions—Effect Utility switch
• CONNECT
• GROUP
• FOOT (Foot Controller)
• MIN VOL (Minimum Volume) @
• AUTO VOL (Auto Volume)
EFFECT
SECTION
MEMORY mode— MEMORY

• Effect program selection—

active
at the
same
time
PATTERN mode— SONG/PATTERN
• Pattern selection & playback—
• Chord entry (change)— CHORD
• Mute on/off— SHIFT + ACCOMP / BASS / DRUMS
SONG mode (Play/Step Recording/Edit
• Song selection and playback—
• Step recording
(recordable data types)
BACKING
• Edit
SECTION
TUNER mode— SHIFT + TUNER
• Tuning
• Center pitch adjustment
MIDI BULK TRANSMISSION mode— SHIFT + MIDI BULK
• MIDI bulk transmission
DEMO mode— SONG/PATTERN + START/STOP
• Song demo play (with effect changes)
• Pattern demo play (with effect changes)
126
JOB TABLE
JOB TABLE
JOB TABLE
CURSOR – / + ) indicates that they are to be pressed in sequence.
ASSIGNABLE block functions
• Effect ON/OFF
• MIN/MAX VOLUME
• AUTO VOLUME
or
CURSOR – / +
ASSIGNABLE block functions
• MEMORY BANK/NUMBER selection
• Effect ON/OFF
• MIN/MAX VOLUME
• AUTO VOLUME
CURSOR – / + START/STOP
, Chord buttons, ON/ROOT
ASSIGNABLE block functions
• BACKING CONTROL
• CHORD RECALL
• Root Select—Pedal switch B +Note played on guitar
or
CURSOR – / + START/STOP
Patterns
}
Chords Make setting(s) & press
Mute
"A"/"B" Location Set—Position Controls
Jumping to "A"/"B"— SHIFT + JUMP-A / JUMP-B
(Loop Recording/Loop Play)— SHIFT + A-B REPEAT
Erase— SHIFT + ERASE
ASSIGNABLE block functions
• BACKING CONTROL
• Triggered Run—Pedal switch B + Pedal Switch 5
or
or
or
Effect Selectior buttons
ENTER
SET-A / SET-B
Note played on guitar