Before Use; Charging The Battery Pack (See Fig. A); Inserting/Removing The Battery Pack; Checking The Battery Charge Level - Parkside PASSP 20-Li A1 Translation Of The Original Instructions

WARNING!
■ To avoid potential risks, if the appliance
power cable is damaged, it must be replaced
by the manufacturer, its customer service or
by a qualified technician.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3.
♦ A current list of battery compatibility can be
found at www.Lidl.de/Akku.

Before use

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Connect the battery pack
battery charger
♦ Insert the mains plug into the mains power
socket. The control LED
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
PASSP 20-Li A1
to the high-speed
(see fig. A).
lights up red.
indicates that the
ATTENTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.

Inserting/removing the battery pack

Attaching the battery pack:
♦ Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Switching on/off
Turn on
♦ Press and hold the ON/OFF switch
up the tool.
The LED work light
OFF switch is pressed lightly or fully. This
provides illumination of the work area in poor
lighting conditions.
Switching off
♦ Release the ON/OFF switch
appliance.
flashes, this means
has overheated and
both
is
into the appliance.
into the
and remove the
to
as follows:
to start
lights up when the ON/
to switch off the
GB │ IE
│
21 ■