Original Accessories/Auxiliary Equipment; Before Use; Charging The Battery Pack (See Fig . A); Attaching/Disconnecting The Battery Pack To/From The Appliance - Parkside PAT 20-Li A1 Translation Of The Original Instructions

Cordless stapler / nailer 20v
Table of Contents

Advertisement

Available languages

Available languages

Original accessories/auxiliary
equipment
Only use the accessories and additional
equipment that are specified in the oper-
ating instructions and compatible with the
appliance.
WARNING!
Do not use any accessories not recom­
mended by PARKSIDE . This can lead to
electric shock and fire .

Before use

Charging the battery pack
(see fig . A)
CAUTION!
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
NOTE
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium­ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level
is between 50% and 80% . The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C .
Connect the battery pack
battery charger
Insert the power plug into the socket .
The control LED
The green LED
indicates that the charging
process is complete and the battery pack
is ready .
PAT 20-Li A1
to the high­speed
(see fig . A) .
lights up red .
ATTENTION!
If the red control LED
that the battery pack
cannot be charged .
If the red and green control LEDs
flash, this means that the battery pack
defective .
Push the battery pack
Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
Allow the battery pack
the appliance .
Removing the battery pack
Press the release button
battery pack
.

Checking the battery charge level

Press the battery charge level button
check the status of the battery (see also main
diagram) .
The status will be shown on the battery display
LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
flashes, this means
has overheated and
both
is
into the appliance .
to click into place in
and remove the
to
GB │ MT
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

373432 2104

Table of Contents