Table of Contents
Advertisement
3.2
Installation Procedure
1.
Unpack the ABHiQV (Fab Rev. C) daughtercard and visually inspect for any damage that may have
occurred during shipping.
2.
Read this ABHiQV (Fab Rev. C) daughtercard User's Guide to become familiar with the board opera-
tions.
3.
Read the DKHiQV-PCI User's Guide to become familiar with the board operations.
4.
Read the MM6555x (Fab. Rev. C) Multimedia Daughtercard User's Guide to become familiar with
board operations.
5.
Read the datasheet applicable to the graphics controller being used.
6.
Verify the appropriate settings for the DKHiQV-PCI board and the ABHiQV (Fab Rev. C) daughtercard
as shown in tables one through six. Refer to Figures 1and 3 for jumper locations.
Caution: Check to ensure all voltage sources are set to 3.3V (consult the DKHiQV-PCI schematics).
Note: For TV-out and multimedia settings, refer to Tables 5 and 6.
7.
Plug the ABHiQV (Fab Rev. C) daughtercard onto the DKHiQV-PCI board. The connectors/header in
the ABHiQV daughtercard is composed of eight 2X16 header-socket-type pins (P1).
8.
Power down the host system and plug the DKHiQV-PCI board into an available PCI slot on the mother-
board.
9.
Connect the monitor to the 15-pin VGA connector. The default configuration of the DK board is for CRT
display.
10. Turn on the system and observe the sign-on message. The sign-on message does not appear, turn
off the system and follow the instructions in the troubleshooting section.
11. Load the proper driver, BIOS and utilities to activate the ABHiQV daughtercard.
&+,36
®
ABHiQV (Fab Rev. C)
User's Guide
Subject to Change Without Notice
Revision 1.1
7/15/98
3
Advertisement
Table of Contents
