Installing The Canopy; Installing The Blades - Hunter Abernathy Installation Manual

1886
Follow these steps to prepare the light fixture for installation.
Remove the pre-installed fixture screws and red
flag from the light kit assembly. Save the screw.
It will be needed for light kit installation.
Note: The screw was installed for shipping purposes only.
7
Ceiling Bracket Downrod

Installing the Canopy

Lift the canopy into place so that
the screw holes are aligned.

Installing the Blades

Put the grommets found in the
onto the blade screws found in the
bag. Then install the blade screws to secure each
blade to the fan.
Preparing the Light Fixture
KEEP
x2
Fixture Screw
Red Flag
Hanging Fan Wiring
Insert the two canopy screws
found in the hardware bag.
hardware bag
hardware
Repeat x5
Carefully remove the light fixture from
the light fixture hood
Canopy Blades Light
x2
Canopy Screw
bag
x15
Blade Screw
bag
x15
Grommet
bag
Glass Remote Remote Cradle