Epson TM-m30II-H Technical Reference Manual page 112

Auto Reconnect
Feature
Printer operations Perform the following reconnection
when is sequence.
disconnected
[Reconnection sequence]
1. The printer tries to connect to the iOS
device to which it was last connected.
2. When step 1 fails, the printer waits for
connections from other devices.
3. If connection is not established in step 2,
the printer tries again to connect to the iOS
device to which it last connected.
Steps 1 and 2 are repeated until a
connection is established.
Reconnecting to iOS Reconnect automatically.
device
Switch to connection Method 1:
from other device
After disabling the
on the
(When the auto reconnect feature is enabled, it may take some time to connect.)
Method 2:
After disconnecting from the connected iOS device using applications with the TM Utility or
Epson ePOS SDK disconnection feature, make settings on the
connect.
∗ In the following situations, even if the feature is enabled, the same operations are performed as when it is disabled.
- When pairing is canceled from the connected iOS device.
- When the last device connected was not an iOS device.
- When wireless communication settings are initialized from the printer.
∗ Disable this feature when using the printer from devices that are not running iOS. Otherwise, it may take some time to connect.
Enabled
feature of the connected iOS device, make connection settings
device that you want to connect.
Disabled
Wait for a connection from the
device.
Make settings on the
on the iOS device.
device you want to
Appendix
settings screen
112