Manual instruction
Installing the water tank (3)
fig.3
13
3
EN
Place the water tank (3) as low as possible
underneath the blade (2).
•
Then completely fill the water tank (3). This tank
(3) is used to cool the blade (2) during operation and
to reduce the quantity of dust when cutting. Be sure
that the water tank (3) is always properly filled with
water.
Installing the parallel guide (8)
Install the guide (8) at the desired width of cut. To do
this, unscrew the knobs for clamping the guide (6)
located on both sides of the parallel guide (8) and
adjust the width of cut, then tighten the two knobs
(6).
fig.4
8
6
fig.5
8
12
1
2
3
4
5
6
7
8
9
10 11 12 13 14 15 16 17 18
Initial operation
Always use the correct supply voltage: the power
supply voltage must match the information quoted
on the tool identification plate.
Operating instruction
Adjusting the cutting angle
fig.6
4
The tile cutter is equipped with a function for
cutting angle adjustment.
To change the cutting angle, simply unscrew the
two cutting angle adjusting knobs (4) which are
situated underneath each side of the machine.
Adjust the work table (9) at the desired cutting
angle (to know the exact cutting angle, refer to the
graduated bar (12)).
NOTE: For high precision works, it is better to do a
trial cut on a useless or unusable piece of tile.
Oblique cut – using the angle gauge (7)
fig.7
7
1
8
2
To make cuts at 45 ° thanks to the angle gauge (7),
place the angle gauge (7) against the parallel guide.
Loose the clamping knobs and position the parallel
12