Attaching The Cap Frame - Brother PRCF5 User Manual

Attaching the cap frame

■ Attaching the lower frame of the cap frame to
the mounting jig
1 Attach the lower frame of the cap frame to
the mounting jig.
Grab the grips on both sides of the lower
frame of the cap frame and push.
When positioning the lower frame of the cap
frame, align the notch in the lower frame
with the guiding plate at the center of the
mounting jig.
1 Grips
2 Guiding plate on mounting jig
3 Notch in lower frame
4 Holders
The cap frame is secured with three
holders.
2 Slide stabilizer under the three tabs on the
lower frame of the cap frame, and then
secure the stabilizer with the pins.
1 Three tabs
2 Pin
• Make sure that the pins go through the
stabilizer to firmly secure it.
■ Attach the cap to the cap frame
1 Set the lock knob on the lower frame to the
locked position.
2 Lightly squeeze the brim of the cap and fit
the upper frame onto the base of the cap
brim.
• Do not force the upper frame to widen.
This may damage the frame.
3 Align the centerline of the upper frame with
the centerline of the cap, and then fit the
teeth at the center and left and right sides of
the upper frame into the base of the cap
brim.
Do this while lightly squeezing the cap brim.
8/15