Brother PRCF5 User Manual page 7

6 Lightly press down the ring, and then use the
Allen screwdriver (large) to firmly tighten
the four hexagonal screws on the inside of
the ring.
1 Ring
CAUTION
●
Make sure that each hexagonal
screw is firmly tightened. If any
screw remains loose, injuries
may result.
Remove the pad inserted in step
7
■ Installing the needle plate spacer
Attach the needle plate spacer (included with
the machine) to the needle plate.
1 Needle plate spacer
■ Preparing the mounting jig
Attach the mounting jig to a stable surface, such
as a desk.
1
Loosen the thumb screw for the mounting jig
to open the mounting bracket so that it is
wider than the thickness of the mounting
surface.
• The mounting bracket can be mounted
2 Securely clamp the mounting bracket onto
the mounting surface by tightening the
5
.
thumb screw.
1 Mounting bracket
2 Mounting surface (worktable, desk, etc.)
3 Tighten the thumb screw.
● If there is a gap between the clamping pad
1 Mounting bracket
2 Mounting surface (worktable, desk, etc.)
3 Pad
4 Thumb screw
6/15
onto a mounting surface with a thickness
between 9 mm (3/8 inch) and 38 mm (1-1/
2 inches).
Memo
of the thumb screw and the mounting
surface, insert the included pad as shown
below.