Brother PRCF5 User Manual page 11

7 Check that the centerline of the cap is
aligned with the projections and V-shaped
notch at the center of the mounting jig.
Check by lightly pressing on the outside of
the cap with your hand.
1 Projections
2 V-shaped notch
Memo
If the centerline of the cap is not aligned
with the projections and V-shaped notch:
1. Set the lock knob on the lower frame to the
unlocked position.
2. Grab the grips of the upper frame and pull
the frame up, and then reposition it so that
it is even on the left and right sides.
3. Set the lock knob on the lower frame to the
locked position again.
6
4. Perform steps
1 Grip
7
through again.
8 Check that the teeth at the center and left
and right sides of the upper frame are fitted
into the base of the cap brim.
1 Base of the cap brim
9 Pull the cap fabric outward from the center
to remove any slack.
0 Use the clips to secure the cap.
1 Clip
• For details on the areas to be secured with
the clips, refer to step
upper frame of the cap frame from the
lower frame" on page 7.
• Repeat steps
remove any slack and secure the fabric
with the clips.
10/15
1
in "Removing the
9 0
and on the other side to