Pioneer DJM-350 Service Manual page 28

1
A
3. Test Possible Area
• The MIC LEVEL control is an exception to testing.
• The MIC equalizer (HI and LOW) controls are exceptions
to testing.
• The TRIM control is an exception to testing.
(The right controls are operating elements that are not
managed by the microcomputer.)
B
C
4. Basic Operation Method
Basic Operation Method
To switch Test modes, use the SEARCH key.
With this unit, the Test mode No. is not normally
indicated.
The Test mode No. is indicated on the level meter
while the TRACK MARK key is held pressed.
If the Test mode is advanced, the PLAY LED flashes
D
once.
If the Test mode is backtracked, the PLAY LED flashes
twice.
Basic Operation Method 2
(For details, see the descriptions for each mode):
In Test 6 mode, the individual operating elements can
be tested. In Test 6 mode, select an operating element,
E using the CH-1 CUE or CH-2 CUE key.
If an unintended erroneous value is displayed when an
operating element is operated, you can reset it by
pressing the MIC/AUX ON key.
In Test 7 mode, the individual LEDs of the level meters
can be tested.
You can light the individual LEDs one after another,
using the CH-1 CUE, CH-2 CUE, or MIC/AUX ON key.
F
28
1
2
[Mode 6]
For going forward/back one operating
element to be tested
[Mode 7]
CH1 and CH2-LED buttons
DJM-350
2
3
[Mode 6]
Reset button
[Mode 7]
MASTER-LED button
For indicating a
Test mode No.
3
4
For going forward
/back one mode
4