Associating Modelsim With Ise 4.1I Project Navigator - Xilinx System Generator V2.1 Reference Manual

Xilinx System Generator v2.1 Reference Guide
Xilinx supplies two sets of instructions for compiling your IP libraries using TCL/TK
scripts. The instructions can be found at the following locations:
MXE libraries
If you plan to use ModelSim XE (Xilinx Edition), download the MXE pre-compiled
libraries from the Xilinx web site. You may find the latest libraries at:
Unzip these MXE libraries into your MXE installed directory (usually $MXE/
xilinx/vhdl/xilinxcorelib). This is the location where MXE expects to find
your Xilinx compiled libraries, so you do not need to make any changes to your
modelsim.ini file. This file should point to the correct installed location.

Associating ModelSim with ISE 4.1i Project Navigator

If you associate ModelSim with the Xilinx 4.1i ISE Project Navigator, then you may
run your simulations from within Project Navigator as part of the full software
implementation flow.
From Project Navigator, choose the main menu pick Edit >> Preferences. This
will bring up a Preferences dialog box. Choose the Partner Tools tab in this
dialog box. Enter the full path to the version of ModelSim on your PC. You must
include the name of the executable file in this field.
Figure 5-9: Associating the ModelSim simulator in Project Navigator
144
http://support.xilinx.com/techdocs/2561.htm
http://support.xilinx.com/techdocs/8066.htm
http://support.xilinx.com/support/software/install_info.htm
Xilinx Development System