Additional Sysgen Parameters - Xerox DocuPrint t 180 System Generation Manual

Additional sysgen parameters

Command
Type of sysgen
System ID
Accounting file
Report accounting
Setting default values
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
In addition to the configuration options listed previously, you may
also need to supply the following information during the system
generation process.
Table 3-5. Sysgen parameters
Description
Sysgen, auto sysgen, or mini sysgen can be performed by selecting
appropriate commands from the Sysgen Command menu (Table 2-1)
Each system can be assigned a name of up to 30 alphanumeric
characters, including spaces.
The ID displays in the following situations:
•
Whenever the system is booted
•
When a rollover and recovery occurs
•
In a rollover dump
•
Whenever a sysgen is performed
•
On listings produced by the Editor
•
On listings produced by the REPORT command to report billing
information.
You are asked if you want to save user accounting information.
Remember that if a currently existing accounting file is not saved, you
lose not only the accounting data but also the hierarchical data used to
structure the file.
You are asked if you want report accounting. This results in run statistics
being recorded for each report, as opposed to each job (which may
contain several reports).
After the sysgen completes, you may want to adjust the following
parameters to which the sysgen automatically assigns default values:
•
Maximum fonts per job (default 32)
•
Maximum forms per job (default 12)
•
Maximum graphics per job (default 32)
•
Print file size (default of 425 cylinders is not determined by a
sysgen).
Refer to the Xerox DocuPrint 180 LPS Operations Reference for
information on modifying these values.
SAMPLE SYSTEM CONFIGURATIONS
3-7