Xerox DocuColor 5252 Operator's Manual page 279

Problem
The Control Panel Touch Screen
does not respond to a touch
command.
You cannot program a job while a
screen is open.
Digital press with scanner features
are not selectable.
Transparencies
Transparencies are too oily.
Do c u Co lo r 52 5 2 O pe r a to r Ma n ua l
Suggested Solution
• Press Clear All on the Control Panel.
• Touch a selectable button on the Touch Screen. A slight
pressure is required to cause the digital press with scanner to
react.
• If the problem persists, open the Front Door of the digital press
with scanner. Close the Front Door and make a selection on
the Touch Screen. If the Touch Screen does not respond to any
touch commands, switch off the power. Wait 15 seconds. Then
switch on the power. Reprogram the digital press with scanner
for the copy features that are desired.
Jobs cannot be programmed or copies made while some screens,
such as administration screens, jam clearance screens, or
consumable status information screens, are open. Follow the
directions on the information screen. Then program the desired job.
Certain features cannot be selected because of the previous
selections. Generally, features or buttons you can select appear
selectable to indicate you can use them with the previous
selections. Refer to the "Overview" chapter for more information
about buttons (see page 3-11).
• Load the transparencies by following the instructions in
Chapter 4, "Paper and Paper Trays (see page 4-9).
• Make 5 blank sheet copies with the Full Color option on paper
stock to purge excess oil from system. Reload the
transparencies and continue the copying job.
• Refer to the Recommended Materials List and the Color
Materials Usage Guide for more information about
transparencies.
P r o b l em s o l vi n g
7-3