Communication Parameter Setup (Printer Control Panel, 6030/6050) - Xerox 6030 User Manual

3.2
Communication Parameter Setup
(Printer Control Panel, 6030/6050)
This section explains the procedures for setting up the communication
parameters from the printer control panel.
Procedure
MENU
PORT SETTING
PORT SETTING
TCP/IP
TCP/IP
Ethernet Setting
Ethernet Setting
AUTO
TCP/IP Setup

3.2 Communication Parameter Setup (Printer Control Panel, 6030/6050)

SNMP must be set up from Print Services on Web.
The changed parameters become valid after the machine is rebooted.
*
1
Press the < > key with [PORT SETTING]
displayed.
2
Select the interface that is to be set up with
the use of the < > and < > keys, and
then press the <
[TCP/IP], [SERIAL], [CENTRO], and [VPI]
will be displayed, in that order.
[CENTRO] and [VPI] are optional.
3
Select the parameters with the use of the
< > and < > keys, and then press the
<Set> key.
An asterisk [*] will be displayed on the right
side of the value once it has been set up.
The changed parameters are saved
to the system when the <Set> key is
pressed. It is not necessary to save
each change individually.
Refer to the previous section for
detailed information about each of
the communication parameters.
4
After setting up all of the parameters, switch
the printer power off and then on for the
changes to take effect.
> key.
69