Xerox Phaser 5500 User Manual page 214

Error or Warning Messages (Continued)
Message
Drum Cartridge Is Near End Of Life
Duplex Unit Failure
Duplicate IP address detected
Exit Unit Failure
Finisher Failure
Finisher Logic Board Failure
Humidity Sensor Failure
Insert Tray [2 | 3 | 4 | 5 | 6]
Description
The Drum Cartridge is near the end of its life.
Order replacement P/N 113R00670.
An error was detected in the Duplex Unit. Printing
continues single-sided.
1. Turn power off.
2. Verify Duplex wire harness is properly connected by
unplugging and reconnecting.
3. Turn power on.
4. If error continues, call Service
Another device on the network is using the IP address
assigned to this printer. Change the IP address of the
printer or the other device.
An error was detected in the Exit Unit. Printing continues
single-sided.
1. Turn power off.
2. Remove and reinstall the Exit Unit.
3. Turn power on.
4. If error continues, call Service.
An error was detected in the Finisher.
1. Turn power off. Printing continues using the Standard
Output Tray.
2. Verify Finisher wire harnesses are properly connected
by unplugging and reconnecting.
3. Turn power on.
4. If error continues, call Service.
An error was detected from the Finisher Logic Board
NVRAM memory. Printing continues using the Standard
Output Tray.
1. Turn power off, then on.
2. If error continues, call Service.
An error was detected in the humidity sensor. Print quality
may be degraded.
1. Turn power off, then on.
2. If error continues, call Service.
Reinsert the indicated tray to continue printing.
Phaser® 5500 Laser Printer
4-61
Front Panel Messages