Furuno WR2120 Installation Manual page 38

10) For reducing from the wind-induced movement, fasten the spring clamp above the base flange
and tighten bottom nut by hand.
* Do not damage the radome gasket when fasten the spring clamps.
* Use the spring clamp properly as examples shown below.
Figure 4.18: Fasten properly by spring clamp
Bad examples:
Figure 4.19: Figure 4.21:
Figure 4.20:
Spring clamp is Fasten spring clamp only
Space between spring clamp
inclined partially
and radome base flange
Approx. 330mm
Figure 4.22: Completion of opening upper radome
32