Xerox 4050 Message Manual page 93

XEROX DOCUPRINT IPS MESSAGES GUIDE
F229 Finishing device full.
The output bin of your third-party finishing device is full.
Action Remove the jobs contained in the device output bin and press the
[Continue] button.
F231 Finishing device not ready.
The third-party finishing device is not ready to perform the task
requested.
Action Check that the finishing device is connected and ready (refer to the
documentation provided with your third-party finishing device, if
necessary) and press the [Continue] button.
F233 Late arrival to the Bypass Transport Jam Sensor.
The paper did not arrive at the bypass transport jam sensor in time.
A jam has occurred.
Action Clear the jam in areas 6 or 6A, 19 and 20, and press the [Continue]
button. (Refer to the Xerox DocuPrint 4850/4890 or 92C IPS
Troubleshooting Guide for the procedure.)
F234 Late departure from Bypass Transport Jam Sensor.
The paper did not leave the bypass transport sensor in time. A jam
has occurred.
Action Clear the jam from area 6 and press the [Continue] button. (Refer to
the Xerox DocuPrint 4850/4890 or 92C IPS Troubleshooting Guide
for the procedure.)
F235 Bypass Transport Cover Open.
The bypass transport cover is not securely in place.
Action Close the bypass transport top cover and retry the operation. Your
service representative will have to fasten the cover.
F236 Bypass Transport Cover Open in Print Mode.
The bypass transport top cover is not securely in place while the
system is attempting to print.
Action Close the bypass transport cover and retry the operation. Your
service representative will have to fasten the cover.
F237 Finishing device offline.
The third-party finishing device is not properly docked to the bypass
transport.
Action Reattach the finishing device, following instructions for your
equipment.
DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
3-21