Xerox 4050 Message Manual page 30

DOCUPRINT 96/4635/180 IPS MESSAGES
2-18
06-253 Extra end of scan signal.
The EOS board detected more than one End of Scan signal.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
06-350 No voltage to modulator drive.
The beam 1 and beam 2 Intensity signals sent from the EPMD board
to the Modulation board are less than +10 VDC, or the Laser Write
signal was missing during printing.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
06-351 Pixel clock input signal fault.
The voltage controlled oscillator that generates the 66 MHz Pixel
Clock signal is out of the acceptable range.
Action Press the [Clear] button located behind the printer control console
front pull-down menu.
06-352 Pixel clock output signal fault.
The 66 MHz Pixel Clock signal was not detected for at least 30
microseconds.
Action Press the [Clear] (or [Reset]) button located behind the printer control
console front pull-down menu.
06-353 ROS LVPS fault.
One or more voltages from the ROS LVPS are more than 30 percent
out of the acceptable range.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
06-354 Polygon motor drive AC fault.
The polygon motor is not receiving the Phase 1 voltage, Phase 2
voltage, or both, from the EPMD board.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
06-355 SOS PWB connector fault.
The SOS board is disconnected, or the +5 VDC was not detected on
the SOS board.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
XEROX DOCUPRINT IPS MESSAGES GUIDE