Xerox 4050 Message Manual page 25

XEROX DOCUPRINT IPS MESSAGES GUIDE
03-404 System comm problem with PHN.
The system is unable to communicate with the PHN.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes. If the error persists,
check the shared lines. If the error still persists, contact your service
representative.
03-405 System comm problem with FSN1.
The system is unable to communicate with the FSN1.
Action Press the [Clear] or [Reset] button located behind the printer control
console front pull-down cover. If the error persists, check the shared
lines. If the error still persists, contact your service representative.
03-407 System comm problem with TMN.
The system is temporarily unable to communicate with the TMN. This
error is logged by the system.
Action No action is required.
03-408 Transient EDN HDLC comm failure.
The System Controller did not acknowledge receipt of the data layer
or client layer operational message from the EDN Core board.
Action Contact your service representative.
03-412 UIM can't talk to any node on bus.
The UIM Core board cannot communicate with any board on the
local bus.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
03-413 MIN can't talk to any node on bus.
The MIN Core board cannot communicate with any board on the
local bus.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
03-414 PHN can't talk to any node on bus.
The PHN Core board cannot communicate with any board on the
local bus.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
DOCUPRINT 96/4635/180 IPS MESSAGES
2-13