Xerox PHASER 3435 User Manual page 57

5 Holding the memory DIMM by the edges, align the notches on the
memory DIMM with the grooves on the memory DIMM slot.
6 Push the DIMM straight into the DIMM slot until it snaps into place.
Make sure the latches fit over the notches located on either side of
the DIMM.
7 Replace the control board cover.
8 Reconnect the power cord and printer cable, and turn the printer
on.
Setting the memory in the PostScript printer
properties
After installing the memory DIMM, you need to select it in the printer
properties of the PostScript printer driver so that you can use it.
1 Make sure that the PostScript printer driver is installed in your
computer. To installing the PostScript printer driver, you need to
select Custom and put a check mark on the PostScript printer
driver. See the Software Section.
2 Click the Windows Start menu.
3 For Windows 2000, select Settings and then Printers.
For Windows XP/2003, select Printers and Faxes.
For Windows Vista, select Control Panel -> Hardware and Sound
-> Printers.
4 Select the Xerox Phaser 3435 printer.
5 Click the right mouse button on the printer icon and select
Properties.
6 For Windows 2000/XP/2003/Vista, select Device Settings tab.
7 Select the amount of memory you installed from Printer Memory in
the Installable Option section.
8 Click OK.
10.2
<Installing accessories>