Xerox WorkCentre 7132 Setup Manual page 2

Prerequisites for Scan to Email Setup
Confirm that:
1. An existing operational network using TCP/IP is available.
2.
The device must be setup with DNS and the Domain Name settings for the network.
have been correctly setup for the multifunction device.
Data to Setup Email
SMTP mail server Host
Name or IP address
SMTP login/password
WorkCentre Email address
Local email addresses
LDAP server address can
be enabled
* Only if the SMTP server requires login and password for authentication.
Procedure for Scan to Email Setup
1.
Enable the Scan to Email option using the instructions in
Option on the WorkCentre
2. Press Login/Logout, then type the UserID 11111 and press Confirm.
3.
From the System Administrator menu, select System Settings.
4.
Select System Settings.
5.
Select Network Settings.
6. Select Port Settings.
7.
Enable the Receive Email port and Send Email port by highlighting each port and
selecting Change Settings.
8.
Select Close several times then Exit. The device will reboot.
9. From a workstation, open up a web browser (such as Internet Explorer), and then enter
the IP address in the format http://xxx.xxx.xxx.xxx (the xxx's represent the device IP
address). If connected properly, you should see a CentreWare Internet Services web
page for your device.
Copyright © 2006, Xerox Corporation. All rights reserved.
Install Requirement
Required
Required*
Required
Optional
LDAP Host Name
on page 1.
2
Scan to Email
Comments
If using an external mail
server, your Internet Service
Provider will provide you
with the mail server name or
IP address.
This email address will fill in
the "From" field on the
emails sent from the device.
A Local Address Book can
be created to store email
addresses.
Displays only email
addresses on the corporate
(LDAP) internal address
book.
Install the Scan to Email