Sis Configuration And Control; Host Control Port; Establishing A Connection; Simple Instruction Set Control - Extron electronics DTP3 T 202 User Manual

SIS Configuration and Control

Use Simple Instruction Set (SIS) commands to configure the devices. This section provides information about
using those commands. The following topics are discussed:
•

Host Control Port

•

Simple Instruction Set Control

•
Using the Command and Response Table
• Command and Response Table for SIS Commands
Host Control Port
The front panel USB-C configuration port can be connected to a host computer for configuration using SIS
commands via an SSH client and IP address (203.0.113.22) on port 22023.

Establishing a Connection

To establish a network connection to a DTP3 device:
1. Download the SSH client software from the internet.
2. Open the SSH client software.
3. Enter the IP address of the DTP3 device in the Host Name or IP address field.
NOTE: The default IP address is 203.0.113.22.
4. Enter 22023 in the Port field.
5. The DTP3 device is password protected, so the appropriate administrator or user name and password must
be entered.
•
If the login and password are correct, the device responds with a copyright message including the
copyright year, the name of the product, firmware version, part number, and the current date and time.
•
If the login and password are incorrect, the Login as prompt returns. Enter the administrator or user
name and password again.
NOTES:
• The DTP3 devices are shipped password-protected. The factory configured passwords for all
accounts on these devices have been set to the device serial number.
•
In the event of a complete system reset, the password converts to the default, which is extron.
New passwords must be configured to secure the device.
•
On password-protected connections, there are two levels of protection: administrator and user.
Administrators have full access to all editing functions.
Simple Instruction Set Control

Host-to Unit Instructions

SIS commands consist of strings (one or more characters per command field). Upper and lower case characters
can be used interchangeably. Commands do not require any special characters to begin or end the command
string. Each response from the transmitter and receiver ends with a carriage return and a line feed (CR/LF = ]),
which signals the end of the response character string.
DTP3 T 202 / DTP3 R 201 • SIS Configuration and Control 13