Table of Contents
Advertisement
SPRAY SYSTEM ASSEMBLY
Perform the following procedure to assemble the spray
system for use. Refer to Figure 16.
LOWER
OUT PORT
PUMP
CLUTCH GUARD
NOT SHOWN
FOR CLARITY
SPRAY
TIPS
1. Connect one end of the suction hose to the IN port
on the pump.
2. Connect the other end of the suction hose to the
suction tube.
3. Connect one end of the return hose to the upper OUT
port on the pump.
4. Connect the other end of the return hose to the return
tube.
PAGE 26 — WSC55 SERIES CHEMICAL SPRAY CART • OPERATION AND PARTS MANUAL — REV. #1 (08/30/19)
UPPER
OUT PORT
RETURN
HOSE
IN PORT
MAIN
HOSE
SUCTION
HOSE
Figure 16. Spray System Assembly
RETURN
TUBE
SPRAY
GUN
MAIN
HOSE
5. Connect the male fitting on one end of the main hose
to the lower OUT port on the pump.
6. Connect the female fitting on the other end of the main
hose to the male fitting on the spray gun.
7. Choose an appropriate spray tip for the desired
application, and install it onto the end of the spray
gun. Always refer to the chemical manufacturer's
recommendations when selecting a spray tip. Refer to
Table 8 for spray tip selection information.
8. Make sure all spray system connections are secure.
SET-UP
RETURN
SUCTION
HOSE
TUBE
SUCTION
HOSE
Advertisement
Table of Contents
