Table of Contents
Advertisement
Assembly Instructions Cont'd
Install Right Front Lift Stop
1. Slide right front lift stop (4) over rockshaft (3).
2. Place spacer plate (2) over front lift stop and
secure both to tractor clutch housing mounting pad
(5) with bolts (7 & 8) and hardened flat washers (9).
NOTE: If loader mounting bracket (1) is installed, do
not use spacer plate. Attach lift stop directly to loader
mounting bracket.
3. Bolt (7) is 5 mm shorter than bolt (8). Use the
shorter bolts (7) in the top holes of spacer plate (2)
and bolts (8) in the center holes.
4. Place a hardened flat washer (9) on bolts (7 & 8)
and insert through spacer plate and into tractor clutch
housing mounting pad (5).
5. Place washers (12) on bolts (11) and through bot-
tom holes. Secure bolts (9) with locknuts (13).
6. Hand tighten all hardware.
7. Position both lift stops and rockshaft so rockshaft
rotates freely, then tighten the 14 mm bolts to 95 lbs.-
ft. and the 1/2" hardware to 85 lbs.-ft. on both front lift
stops.
8. Place washer (10) over rockshaft and secure with
spirol pin (6).
1.
Loader mounting bracket (if installed)
2.
Spacer plate
3.
Front rockshaft assembly
4.
Right front lift stop
5.
Tractor clutch housing mounting pad
6.
1/4 x 2" Spirol pin
7.
14 mm x 35 mm Bolt
8.
14 mm x 40 mm Bolt
9.
9/16" Hardened flat washer
10.
1" Flat washer
11.
1/2 x 1-3/4" Bolt
12.
1/2" Flat washer
13.
1/2" Flanged locknut
MAN0137 (9/14/01)
Figure 23 Right Front Lift Stop Installation
Assembly 31
Hide quick links:
Advertisement
Table of Contents
