Table of Contents
Advertisement
DEALER SERVICE
Cont'd
Install Drive Pulley
1. Install drive pulley (19) with split taper bushing
20
(12) on gearbox vertical shaft. Make sure key (82)
and keyways are aligned.
2. Position center line of drive pulley (19) 15/16"
(plus or minus 1/32") above mounting surface of gear-
1-7/8"
box stand (20) as shown. This is a very critical
dimension and must be held.
19
3. Alternately tighten split taper bushing set screws
12
82
15/16"
to 14 lbs.-ft. Check mounting distance to make sure it
DB2938
is correct.
Figure 20 Drive Pulley Dimensions
NOTES
26 Dealer Service
MAN0137 (9/14/01)
Hide quick links:
Advertisement
Table of Contents
