Woods 7000, 7192, 7194, 7195, 7200, 7205 Manual page 23

DEALER SERVICE
Cont'd
Install Blade Spindle
44
IMPORTANT
■
Pulley installation sequence is very important
45
47
for bearing life. Follow the sequence exactly.
1. Insert spindle through bottom of mower deck and
42
install three mounting bolts. Be sure to position
grease fittings toward lubrication access areas.
17
2. Install pulley (16) and split taper bushing (17) with
integral key on spindle shaft.
3. Install bolt (44) and flat washer (45) in top of spin-
dle shaft. Torque this bolt to 12 lbs.-ft.
4. Install split taper bushing bolts (47) and lock
washers (42).
16
5. Alternately tighten and torque to 12 lbs.-ft.
DD3413A-1
Figure 11 Spindle Installation
Replace Oilite Bushings
1. Six pre-oiled bronze Oilite bushings are used in
Left Rear Rockshaft Mount
the lift mechanism, two in front and four in rear (see
Figure 12). Oil these bushings once a year to extend
their life cycle.
2. When replacement is required, use a new bush-
ing to press the old bushing out. Make sure the new
bushings are pressed in flush.
Oilite Bushing
Left Front Lift Stop
Oilite Bushing
LA2
Figure 12 Oilite Bushing Location
Dealer Service 21
MAN0137 (9/14/01)