Mounting To Part-Turn Actuator - Siemens SIPART PS100 Operating Instructions Manual

9. Keep the positioner and the fastening bracket on the actuator. Ensure that the carrier pin
is guided inside the pick-up bracket
10.Fasten the positioner on the yoke.
Figure 3-6
3.3

Mounting to part-turn actuator

Requirements
● An actuator-specific VDI/VDE 3845 mounting console
● Mounting kit 6DR4004-8D
Procedure
Sr. Quan Name
no. * tity
)
①
1 Coupling wheel
②
1 Carrier
③
1 Multiple plate
8 Scale
2 Pointer mark
④
Mount
⑤
4 Hexagon bolt
⑥
4 Lock washer
⑦
1 Socket cap screw
⑧
1 Washer
⑨
1 Hex socket-head
screw
⑩
1 Square nut
1 Machinist's wrench
The numbers refer to the images of the description of the installation steps below.
*)
SIPART PS100
Operating Instructions, 11/2019, A5E45863537-AC
Fastening to various yoke types
"Part-turn actuator" mounting kit 6DR4004–8D
Note
Installation on positioner shaft
Installing on the actuator shaft
Display of the position, consisting of scale and pointer mark
Different divisions
Reference point for scale
Actuator-specific, VDI/VDE 3845
M6x12 DIN 933, torque see the section "Technical specifications > Mechanical con‐
struction (Page 39)"
S6
M6x16 DIN 84
6.4 DIN 125
M4 for coupling wheel
M4 for coupling wheel
For hexagon socket-head screw
3.3 Mounting to part-turn actuator
②
.
⑨
Installing and mounting
④
13