Setting The Camera Conditions; Checking The Camera Connections: [Camera Connection]; Setting The Trigger Delay: [Inter-Camera Setting] - Omron SYSMAC FH Series User Manual

Setting the Camera Conditions

Checking the Camera Connections: [Camera Connection]

You can check whether a Camera is connected. There are no settings.
1
In the Main Window, select [System settings] − [Camera] − [Camera Connection] from the
[Tool] menu.
The Camera Connection Settings View is displayed.
2
Check the connection status.
If a Camera is connected, the model name of the
connected Camera will appear next to the Camera
number.
If the [Disconnect] is displayed even though a
Camera is connected, there could be a failure or a
disconnected line. Check the physical connection.
3
Click the [Close] Button.

Setting the Trigger Delay: [Inter-camera setting]

This setting is used to set the delay time from when the STEP signal for the input trigger is received to when the
shutter is triggered. You can use this to prevent mutual interference caused by the lighting when more than one
Camera is used, or as a simple trigger delay when only one Camera is used.
Note
Set the STGOUT pulse width in the [Electronic flash setting] under the [Camera Image Input] processing item.
Reference: Electronic Flash Setting of the Vision System FH/FZ5 Series Processing Item Function Reference Manual
(Cat No. Z341).
ON
STEP
OFF
ON
Camera 0
shutter trigger
OFF
ON
Camera 1
shutter trigger
OFF
ON
STGOUT0
OFF
ON
STGOUT1
OFF
264

Setting the Camera Conditions

WWW.NNC.IR
Vision System FH/FZ5 Series
User's Manual (Z340)