Omron SYSMAC FH Series User Manual page 297

IMPORTANT
• Do not set [EtherNet/IP] and [PLC Link] at the same time. They cannot be used at the same time.
Example:
Set [Serial (Ethernet)] to [PLC Link] and [Fieldbus] to [EtherNet/IP] at the same time.
Set [Serial (RS-232C/422)] to [PLC Link] and [Fieldbus] to [EtherNet/IP] at the same time.
Set both [Serial (Ethernet)] and [Serial (RS-232C/422)] to [PLC Link], and set [Fieldbus] to [EtherNet/IP] at the same
time.
• Do not set both [Serial (Ethernet)] and [Serial (RS-232C/422)] to [PLC Link]. They cannot be used at the same
time.
Note
• Normal (Fxxx Series Method)
With the [Normal (Fxxx series method)] communications method, the OK response timing in relation to
MEASURE commands is different from that of the [Normal] communications method.
Normal (Fxxx series method) communications method
MEASURE
Measurement result
OK
• OK Responses
With [Normal communications method], an OK response is returned when the Controller receives a command.
With [Normal (Fxxx series method)], an OK response is returned when command execution is completed.
Operation Mode (FH and FZ5-11
Select the operation mode according to the application conditions, such as the operation mode that is best
suited to reduce the takt time and downtime.
Refer to Setting the Operation Mode (p.268) for details on the operation modes.
Item
• Single-line High-speed mode
• [High-speed logging mode]
Operation mode
• Multi-line random-trigger mode
• Non-stop adjustment mode
Parallel
ON/[OFF]
execution
3
Click the [Apply] button.
Vision System FH/FZ5 Series
User's Manual (Z340)
Only)
Set value [Factory default]
WWW.NNC.IR
Normal communications method
MEASURE
OK
Measurement result
Description
Set the operation mode.
Reference: Setting the Operation
Mode (p.268)
Set whether to uses parallel processing.
Reference: Parallel Processing
Settings (Automatic Parallelization)
(p.282)
Setting the Operating Environment of the System
7
295