Table of Contents
Advertisement
X-LINE ADVANCE install system rigging
3
Installation
3.1
Attaching grid to top element of array
Notice!
A 17 mm socket, a 6 mm hex driver, a medium strength threadlocker (Loctite® 243 or
equivalent) and a torque wrench are required for the installation of the line array.
Warning!
PREVIEW Loudspeaker Software MUST be used to design the array. PREVIEW will state
!
whether the array configuration is valid for use with the X12i-RIGKIT and X12i-GRID
accessories. Follow all warnings within the software. Failure to design the array properly may
result in serious injury or death.
1st
Bosch Security Systems B.V.
1.
Use PREVIEW Loudspeaker Software to design the
array. PREVIEW will determine whether the array
can be suspended with the optional grid and rigging
kits for your particular application, with the safety
factor that you determine based on local laws and
regulations.
2.
If PREVIEW states the array configuration is valid,
the optional grid and rigging kit may be used to
suspend the array.
3.
If PREVIEW determines that the desired array
configuration is not valid or not possible, a custom
rigging solution is needed. Please consult the X-Line
Advance Install User manual, available at
www.electrovoice.com.
Rigging manual
Installation | en
7
2020-06 | V03 | F01U361023
Advertisement
Table of Contents
