Installation And Wiring; Installing The Speaker - Electro-Voice EVID S Series Installation Manual

8 en | Installation and wiring
3

Installation and wiring

3.1

Installing the speaker

For safety, ensure the mounting surface supports more than the weight of the speaker. Use
only industry-accepted fasteners and mounting methods when mounting the U-Bracket.
Consult an expert if you are unsure.
Warning!
Use a support system which has sufficient wind load strength to comply with the applicable
!
codes and standards.
Disregarding this warning could result in damage to the product and major injury or possibly
death may occur.
Caution!
It is the installer's responsibility to determine and use the proper mounting hardware for the
!
wall construction type.
Disregarding this caution could result in damage to the product and personal injuries may
occur.
Notice!
i
Connections shall not be made with rigid conduit but with flexible conduit or wiring only.
Installing the U-Bracket
To install the U-bracket, do the following:
1.
2.
3.
Installing the speaker
To install the speaker, do the following:
1.
2022-03 | 07 | F.01U.345.358
Draw a level line.
Align screw holes on the level line.
Install two mounting screws to secure the U-Bracket to the wall.
Wire the speaker, as shown in the wiring section.
Installation Manual
EVID Surface Mount S Series - X Models
Electro-Voice