Attaching Elements Under The Top Element - Electro-Voice X‑LINE ADVANCE X1i Rigging Manual

X-LINE ADVANCE install system rigging
3.2

Attaching elements under the top element

Warning!
Only use hardware with a working load limit that exceeds the total weight of the array. Any
!
hardware used to connect between the grid spreader bars and the venue not provided by
Electro-Voice is the responsibility of others.
A
Bosch Security Systems B.V.
1.
2.
3.
M10
6mm
4.
B
Rigging manual
Place the next element in the array underneath the
previously assembled element. The orientation of the
next element must be the same as the previous
assembled elements.
Remove the top M10 flat head screw on each side of
the next element in the array.
Set aside screws to be properly recycled later.
Determine whether the splay angle on the next
element is an even or odd number in PREVIEW.
Option A: If the splay angle is an even number,
orient the rear link bar so that the even numbers are
above the next element and facing the rear of the
element.
Option B: If the splay angle is an odd number, orient
the rear link bar so that the odd numbers are above
the next element and facing the rear of the element.
Installation | en 13
2020-06 | V03 | F01U361023