Mitsubishi Electric Melservo MR-J5-A User Manual page 41

Operation method
■Servo parameter in hexadecimal
The operation method example is shown below when [Pr. PD03 Input device selection 1L] is set to "00022002". Press
"MODE" to switch to the basic setting parameter screen.
Press the "SET" button once.
Change the setting value using
the "UP" or "DOWN" button.
Press the "SET" button once.
■Servo parameter in decimal
The following example gives the operation procedure to change [Pr. PA06 Electronic gear numerator] to "1234567890".
Press the "MODE" button once.
Setting of the first 4 digits
Press the "SET" button once.
The screen blinks.
Change the setting value using
the "UP" or "DOWN" button.
Press the "SET" button once.
The setting value is
determined.
Press the "MODE" button once.
Press the "MODE" button once.
Setting of the first 4 digits
The screen blinks.
The setting value is determined.
Press the "MODE" button once.
Press the "MODE" button once.
Setting of the middle
4 digits
Press the "SET" button once.
The screen blinks.
Change the setting value using
the "UP" or "DOWN" button.
Press the "SET" button once.
The setting value is
determined.
Press the "MODE" button once.
Press the "MODE" button once.
The servo parameter number is displayed.
Press "UP" or "DOWN" to change
the number.
Press the "SET" button once.
Setting of the last 4 digits
Press the "SET" button once.
The screen blinks.
Change the setting value using
the "UP" or "DOWN" button.
Press the "SET" button once.
The setting value is determined.
The parameter number is displayed.
Press "UP" or "DOWN" to change
the number.
Press the "SET" button once.
Setting of the last 4 digits
Press the "SET" button once.
The screen blinks.
Change the setting value using
the "UP" or "DOWN" button.
Press the "SET" button once.
The setting value is determined.
3.2 Switch setting and display of the servo amplifier
3
3 STRUCTURE
39