D-Link DI-804 Connection Manual page 17

With DSL-302G the setup is similar. This modem uses 10.1.1.1 address on LAN.
In order to enable VPN traffic passthrough in this modem you need to do the following:
Log into the modem's WEB interface and select WAN > NAT. Under NAT Options select NAT Rule
Entry. Click on Add button.
Under Rule Flavor select BIMAP. Set Rule ID as next number in the rules table (in our case it is 2). IF
Name = ALL. Local Address will be the IP on the WAN port of your DI-804HV which is connected to
this modem. Global address leave as 0.0.0.0:
Then click on Submit to apply the settings.
When setting up Remote Gateway in VPN you will need to use public IP on DSL-302G's WAN port.
D-Link Australia & NZ Technical Support Team can be contacted on +61 2 88991800 or support@dlink.com.au
~ End of Document ~