Windsor Saber Compact 22 User Manual page 12

metering equipment. Always rinse at the
end the fresh water tank and the appliance
with clear water. To rinse, open the regula-
ting knob fully and set the cleaning program
with water at the program selection switch.
Open the cover of the fresh water reser-
voir.
Fill in the water up to the MAX marking of
the filling level display. Maximum tempe-
rature of the liquid 60°C (140 °F).
Close the cover of the dirty water reser-
voir.
Close the lid of the detergent bottle.
Screw the lid provided with the metering
equipment on to the detergent bottle.
Tilt out the detergent intake.
Insert the detergent bottle in the deter-
gent intake with the lid pointing down-
wards and push it in.
Tilt back the detergent intake.
Driving to the Place of Use
When the running gear is driven out the ap-
pliance can be pushed to the place of use wi-
thout any contact of the brushes with the
floor.
Raise the squeegee tool.
Move out the pedal to drive out the run-
ning gear towards the right and release it
upward.
Briefly press the handle downward so
that the chassis can drive out.
Use the pushing handle to push the ap-
pliance to the place of use.
12
English
Cleaning Programs
1 Driving to place of use.
2 Scrub cleaning Wet cleaning the floor
and vacuum up dirty water.
3 Wet scrubbing Wet cleaning the floor
and allow the detergent to react.
4 Vacuuming up the detergent solution.
5 Polishing the floor without the application
of liquid.
6 Scrubbing and suction without adding
water (polish suction) Polish floors wit-
hout applying water and suck in the poli-
shing dust (accessory)
Battery control display
The battery control display shows the char-
ging status of the batteries when the charger
has been connected:
40-100% glows green
20-40% glows yellow
0-20% slowly blinks red
empty glows red