Vacuum Motor - Windsor Saber Cutter 10052400 Operating Instructions Manual

11.

VACUUM MOTOR

(Refer to the Vacuum Group in the parts section of
manual)
! WARNING
Do not use a pressure washer to clean around the
vacuum motors. Use tap pressure only. Care
must be taken so that water is not directed into
vacuum motor air intakes.
CHANGING VACUUM MOTOR
1. Disconnect batteries from machine.
2. Remove front cover.
3. Disconnect electrical connector to the vacuum
motor.
4. Loosen clamp and disconnect hose from vacuum
intake.
5. Remove vacuum motor mounting bracket bolts.
6. Remove vacuum motor from mounting bracket.
7. Reverse steps to install.
Vacuum Motor Carbon Brushes Replacement (Windsor)
Carbon
Brushes
If armature commutator is grooved, extremely pitted or not
concentric, the motor will need to be replaced or sent to a
qualified service center.
Important:
These brushes wear quicker as the length shortens
due to increased heat. Spring inside brush housing
will damage motor if brushes are allowed to wear
away completely.
Periodically check the length of the carbon brushes.
Replace both carbon brushes when either is less than
3/8" (9.5mm) long.
End Cap
3
8 [9.5mm]
CUTTER 36V 86039100 05/01/07
Vacuum Motor Carbon Brushes Replacement (Ametek))
Carbon
Brushes
If armature commutator is grooved, extremely pitted or not
concentric, the motor will need to be replaced or sent to a
qualified service center.
Important:
These brushes wear quicker as the length shortens
due to increased heat. Spring inside brush housing
will damage motor if brushes are allowed to wear
away completely.
Periodically check the length of the carbon brushes.
Replace both carbon brushes when either is less than
3/8" (9.5mm) long.
MAINTENANCE
End Cap
Note:
Place
stop in
groove.
3/8 (9.5mm)
4-11