White Rodgers 1F92W-51 Installation & Operation Manual page 8

1. Probe for obstructions in partition before drilling
1
⁄ " hole in wall at selected location. Take up
2
quarter round and drill a small guide hole for
sighting (see fig. 1). From basement, drill
in partition floor next to guide hole. In buildings
without basements, drill
and into partition from above (see fig. 1).
2. Through this hole drop a light chain, or 6" chain
attached to a strong cord. Snag cord in basement
with hooked wire. In buildings without base-
ments, drop cord through hole in ceiling and
down partitioning; snag cord at the thermostat
location.
3. Attach thermostat wires to cord and pull wires
through hole in wall so that 6" of wire comes out
of the wall.
8
3 ⁄ " hole
4
1 ⁄ " hole through ceiling
2
1
⁄ " hole for
2
thermostat wire
Stout cord with 6"
chain attached
Baseboard
strip moulding
1
⁄ " guide hole
4
for sighting
Quarter round
removed
Hooked wire for snagging chain
Figure 1. Routing thermostat wires
Approximately
5 feet from floor
3
⁄ " hole in floor of partition
4