New Installation; Installing Your Thermostat; Route Wires To Location - White Rodgers 1F92W-51 Installation & Operation Manual

White-rodgers installation & operation guide multi-stage/heat pump electronic digital thermostat 1f92w-51
Table of Contents

Advertisement

NEW INSTALLATION

WE RECOMMEND THAT YOU PROGRAM THE
THERMOSTAT WITH BATTERY INSTALLED BE-
FORE ATTACHING ON SUBBASE. SEE OPERA-
TION SECTION FOR PROGRAMMING INSTRUC-
TIONS.
SELECT THERMOSTAT LOCATION
Proper location insures that the thermostat will
provide a comfortable building temperature. Ob-
serve the following general rules when selecting
a location:
1. Locate thermostat about 5 ft. above the floor.
2. Install thermostat on a partitioning wall, not on an
outside wall.
3. Never expose thermostat to direct light from
lamps, sun, fireplaces or any temperature radiat-
ing equipment.

INSTALLING YOUR THERMOSTAT

4. Avoid locations close to windows, adjoining out-
side walls, or doors that lead outside.
5. Avoid locations close to air registers or in the
direct path of air from them.
6. Make sure there are no pipes or duct work in that
part of the wall chosen for the thermostat loca-
tion.
7. Never locate thermostat in a room that normally
warmer or cooler than the rest of the building.
8. Avoid locations with poor air circulation, such as
behind doors or in alcoves.

ROUTE WIRES TO LOCATION

All wiring must conform with local and national
electrical codes and ordinances.
NOTE
7

Advertisement

Table of Contents
loading

Table of Contents