Table of Contents
Advertisement
Before you begin programming your new thermo-
stat, you should be familiar with its features and with
the display and the location and operation of the
thermostat buttons. The information in this section
will help you become familiar with your thermostat so
that you can easily program it.
Your thermostat consists of two parts: the thermo-
stat body and the subbase.
CAUTION
!
SYSTEM
Use
to turn the thermostat OFF
HEAT-OFF-COOL-AUTO
before removing or attaching the thermo-
stat body. Equipment damage and/or per-
sonal injury could occur.
22
OPERATING YOUR THERMOSTAT
The subbase is attached to the wall, but you can
remove the thermostat body for easy programming.
To remove the thermostat body from the subbase,
grasp the thermostat body and gently pull it straight
out from the subbase (see fig. 9). To attach the
thermostat body, line up the four terminal pins on the
upper section of the thermostat back with the match-
ing connector on the subbase. Insert these, then
gently pivot the thermostat body down to connect the
PULL STRAIGHT OUT
Figure 9. Removing thermostat from subbase
Advertisement
Table of Contents
