Canon NEW F-1 Service Manual page 8

7. Adjust the rewind crank (22) slip torque by changing the friction washer (21).
Torque Limits: 35 to 55 gcm.
8. Lubricate both sides of friction spring (20) with PL-015.
9. Hold the rewind fork. Raise the rewind crank knob and turn in
the rewind direction. The clutch should engage within one half
turn,
10. To install the ASA Dial, set the SV wiper wiper pin as shown and align the "1/2"
on the exposure compensation dial with the index.
11. Check the difference in height between the rewind crank bushing and the "A"
and "B" surfaces. Install a slightly thinner washer as indicated below.
11.1. Washer (30) "A" Difference Check at four points.
Ex: Difference
0.15mm
0.2mm
0.1mm
11.2. Washer (29) "B" Difference
Ex: Difference
0.55mm
0.4mm
0.35mm
Note:
on page 6. Disassemble in normal order and reassemble in reverse
order.
Canon NEW F-1 Service manual
Assembly and Adjustment Notes
Washer "t"
--- 0.1mm
--- 0.2mm
--- No washer
Wacher "t"
--- 0.5mm
--- 0.4mm
--- No washer
Numbers in parentheses in the text correspond to circled numbers
Page 8