Canon NEW F-1 Service Manual page 13

Disassembly Notes
1. To remove the main circuit board (6), the
lower body flex must be moved slightly.
2. When the battery cover is removed,
temporarily replace the earth (grounding)
screw.
Assembly and Adjustment Notes
1. Apply electrolub to the connector portions
of the main circuit board (6) and lower
body flex.
2. Clean the elastic connectors (2) and (7)
with electrolub.
3. Install cushion II (4) as shown below.
Note: Numbers in parentheses in the text correspond to circled numbers on
page 12. Disassemble in normal order and reassemble in reverse order.
Canon NEW F-1 Service manual
Assembly and Adjustment Notes
4. Clean the connector portions of the resistor
board (R Board) (9) and main circuit board
(6) (rear side) and apply electrolub.
5. Install the resistor board (9) into the body.
Put diabond on the rear of the board
around the mounting holes.
6. Battery Chamber Unit (10) Post
Installation Checks
6.1.
6.2.
7. Install cushion I (11) as shown below.
Push it in until it is flush against the main
circuit board and diabond it to the body.
Page 13
Without a battery installed, the
swinging release rod (p/6 the battery
chamber unit) must overlap the
release pin below it by at least 1/2 the
pin diameter.
When the minus contact of the
battery box is pressed down and then
released slowly, the
rod must return completely and
smoothly.