Canon NEW F-1 Service Manual page 11

Disassembly Notes
13. If the SV board is to be removed,
remove the white cord from the P.C.
Terminal.
If the SV board is not going to be
removed, lift the front panel and
unsolder to white cord from the front
panel (SW16') end.
14. Remove the plastic foam light shields
from the battery box area.
15. If the moisture seal rubber around the
main circuit board is damaged, replace
it.
Note: Numbers in parentheses in the text correspond to circled numbers on page 6.
Canon NEW F-1 Service manual
3.1.
3.2.
3.3.
3.4.
Page 11
Assembly and Adjustment Notes
2.4 In the order shown in figure 2, set the
levers as shown in figure 3.
Fig. 2
With the levers positioned as in figure
3, install so they are between the mirror
charge and signal levers (Fig. 1. page
6).
Caution: If this operation is not done
correctly, winding timing will
be incorrect and the shutter
will not cock.
While performing the above step, it is
possible that the signal lever will get
pushed out of position. Check that the
levers are positioned as shown below.
(Another method is to hold the
intermediate signal lever toward the
mount side while installing the unit.)
While holding the body 1
latch lever out of the way, position the
1st curtain start lever toward the rear.
Put Arontite R on the threads of the
mirror striker lever screw before
installing it.
Fig. 3
st
curtain