Hitron CDA3-35 User Manual page 15

When you turn on the CDA3-35, the LEDs light up in the following order:
POWER
DS
US

The Status and LAN LEDs light up as soon as there is activity on the port IP
Address Setup.
Before you start the CDA3-35's GUI, your computer's IP address must be in the same
subnet as the CDA3-35. This allows your computer to communicate with the CDA3-
35.
NOTE: See IP Addresses and Subnets
The CDA3-35 has a built-in DHCP server that, when active, assigns IP addresses to
computers on the LAN. When the DHCP server is active, you can get an IP address
automatically. The DHCP server is active by default.
If your computer is configured to get an IP address automatically, or if you are not
sure, try to enter the CDA3's IP address (default 192.168.100.1) in the URL bar in a
opened browser window (see
If the GUI screen displays, your computer is already configured correctly.
If the GUI screen does not display, either the CDA3-35's DHCP server is not
active or your computer is not configured correctly. Follow the procedure in
Manual IP Address Setup
address automatically. Try again. If you cannot see the GUI screen, follow the
manual IP address setup procedure again, and set a specific IP address as
shown. Try again.
NOTE: If you still cannot see the GUI screen, your CDA3-35's IP settings may have
been changed from their defaults. If you do not know the CDA3-35's new
address, you should return it to its factory defaults. See
35 on page 18. Bear in mind that ALL user-configured settings are lost.
15 15 Version 1.0, 05/2015. Copyright
Version 1.0, 05/2015. Copyright
on page 20
GUI Overview on page 17).
on page 16 and set your computer to get an IP
CDA3-35 User's Guide
for background information.
Resetting the CDA3-
2012 Hitron Technologies
2015 Hitron Technologies
INTRODUCTION