Table of Contents
Advertisement
Electrical Connections
These electrical diagrams are recommended for the most commonly used accessory combinations. Wiring diagrams for the
MSLV, CC202, CC101, and AS101 are supplied with the product.
NOTES: • All electrical connections must comply with local electrical codes.
• Pressure switches may be connected across the line at 5 horsepower or less. Larger horsepower motors require
connection in the pilot circuit of a magnetic starter.
• The magnetic and manual starters supplied by In-Sink-Erator do not require heaters to complete the circuit.
In-Sink-Erator disposers are equipped with overload protectors.
• A time delay may only be used with a water solenoid valve.
DANGER
Electrical Shock
• Turn off all electrical supply to the disposer before attempt-
ing any work on it. Use a voltmeter or circuit tester to
ensure power is off.
• Installation must conform to all local electrical codes.
• All control centers and disposers must be carefully and
permanently grounded.
• A properly fused disconnect must be installed at the electri-
cal supply source for the control center.
Disposer Motor Wiring
Start
Switch
Wiring Diagrams
Overload
Protector
Property Damage
• Ensure that the control center voltage and phase match
the disposer motor and electrical supply. Check name-
plates on disposers and control centers for voltage and
phase specification.
• The disposer motor wiring connection is shown in the
disposer terminal box.
10
Start
Switch
Overload
Protector
Hide quick links:
Advertisement
Table of Contents
