Changing To Straight Stitch Plate - Husqvarna Viking Designer Sapphire 85 User Manual

Snap on and Remove the Presser Foot
3. With presser foot bar in the up position, place the presser
foot under the dual feed.
4. Push the foot upwards so that it snaps into place.
5. To remove the foot, push the front of the foot upwards
until the foot snaps off.
Note: Always keep the dual feed with a foot snapped-on when it is
not attached to the machine.
How to Attach the Guide
The two edge/quilting guides included with your machine
will help you sew parallel rows of stitching side by side as in
channel quilting or tucking. There is one guide for the left
side, and one for the right.
6. Insert the guide into the hole in the back of the dual feed.
Adjust the space between the foot and the guide by
pulling it to the left or to the right.
Note: The edge guides can also be used without the dual feed. Insert one
into the hole at the back of the presser foot ankle and tighten the screw.

Changing to Straight Stitch Plate

The Straight Stitch Plate is recommended for embroidery. It
may also be used for certain techniques in sewing mode, such
as quilt piecing. The smaller hole in the Straight Stitch Plate
supports the fabric closer to the needle and helps prevent the
fabric from being pulled down into the bobbin area,
especially at the beginning and/or end of a seam.
1. Remove the presser foot and slide off the bobbin cover.
2. Make sure that the feed teeth are lowered. Place the
screwdriver under the needle plate as shown in the
picture and gently turn the screwdriver to pop off the
needle plate.
Note: Lower the feed teeth by touching the presser foot up and extra
lift button.
Note: When changing the needle plate, clean any lint and threads
from the bobbin area.
3. With feed teeth lowered, place the straight stitch plate so
that it fits into the notch at the back (A). Press the
straight stitch plate down until it clicks into place. Slide
on bobbin cover.
To prevent needle breakage or damage to the plate, remove
any accessory that is not compatible with the Straight Stitch
Plate, such as twin needle.
36
3
4
1
A
3
2 Preparations
5
6
2